Food Inspections

Moonie's Texas Barbecue

Inpection Notes

4-2B - food-contact surfaces: cleaned & sanitized 511-6-1.05(7)(a)1 - equipment, food-contact surfaces,& utensils (pf) Points: 4 Corrected during inspection?: Yes Repeat: No Inspector Notes: Observed buildup of slime on soda dispensing nozzles. 511-6-1.05(7)(a)1 - Equipment, Food-Contact Surfaces,& Utensils (Pf) (7) Cleaning of Equipment and Utensils. (a) Equipment, Food-Contact Surfaces, and Utensils. 1. Equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf. COS: Manager will remove the nozzles for cleaning at the end of the day. Will return in 10 calendar days to follow up. 6-1A - proper cold holding temperatures 511-6-1.04(6)(f) - time/temperature control for safety; cold holding (p) Points: 9 Corrected during inspection?: Yes Repeat: No Inspector Notes: Observed reach in cooler in the back of house area observed to be greater than the 41°F threshold. Dairy products (Milk and Heavy Whipping Cream) in the cooler were at temperatures noted in the temperature log above 41 Degrees Fahrenheit. 511-6-1.04(6)(f) - Time/Temperature Control for Safety; Cold Holding (P) (f) Time/Temperature Control for Safety Food, Hot and Cold Holding. Except during preparation, cooking, or cooling, or when time is used as the public health control, time/temperature control for safety food shall be maintained at 41°F (5°C) or below or 135°F (57°C) or above, except that roasts cooked to a temperature and for a time specified in subsection (5)(a)2 of this Rule and reheated using the same temperature and time conditions as cooking may be held at a temperature of 130°F (54°C) or above. P COS: The manager immediately discarded the products in the reach in cooler due to the items being greater than 41°F. 11A - proper cooling methods used: adequate equipment for temperature control 511-6-1.04(6)(e) - cooling methods (pf, c) Points: 3 Corrected during inspection?: Yes Repeat: Yes Inspector Notes: Observed Mac n' Cheese pans covered fully with a lid in the walk-in cooler while cooling. 511-6-1.04(6)(e) - Cooling Methods (Pf, C) (e) Cooling Methods. 1. Cooling shall be accomplished in accordance with the time and temperature criteria specified under DPH Rule 511-6-1-.04(6)(d) by using one or more of the following methods depending on the type of food being cooled: (i) Placing the food in shallow pans; Pf (ii) Separating the food into smaller or thinner portions; Pf (iii) Using rapid cooling equipment; Pf (iv) Stirring the food in a container placed in an ice water bath; Pf (v) Using containers that facilitate heat transfer; Pf (vi) Adding ice as an ingredient; Pf or (vii) Other effective methods. Pf 2. When placed in cooling or cold holding equipment, food containers in which food is being cooled shall be: (i) Arranged in the equipment to provide maximum heat transfer through the container walls; and (ii) Loosely covered, or uncovered if protected from overhead contamination during the cooling period to facilitate heat transfer from the surface of the food. COS: The EHS corrected the cooling method, by uncovering the Mac to ensure an adequate cooling curve in accordance with the DPH regulations for proper cooling methods. 15C - nonfood-contact surfaces clean 511-6-1.05(7)(d) - nonfood-contact surfaces (c) Points: 1 Corrected during inspection?: No Repeat: No Inspector Notes: Observed build-up of dust/soil residues on the hood in the back of house, which is a nonfood-contact surface. 511-6-1.05(7)(d) - Nonfood-Contact Surfaces (C) (d) Nonfood-Contact Surfaces. Nonfood-contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues.

Back to Food Inspections