Food Inspections

Peyton's Pie Company

Inpection Notes

4-2B - food-contact surfaces: cleaned & sanitized 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf) Points: 4 Corrected during inspection?: Yes Repeat: No Inspector Notes: The dish washing machine at the front customer service area measured 0ppm of Chlorine when tested with a Chemical Test kit. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) Note: The facility will use the dish machine in the kitchen, until the mini dish machine at the front customer service area is repaired. 11D - thermometers provided and accurate 511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c) Points: 3 Corrected during inspection?: Yes Repeat: No Inspector Notes: No thermometer was observed in the reach in cooler unit by the Pizza Oven. 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. 2. Except as specified in paragraph 3 of this subsection, cold or hot holding equipment used for time/temperature control for safety food shall be designed to include and shall be equipped with at least one integral or permanently affixed temperature measuring device that is located to allow easy viewing of the device's temperature display. 3. The requirement in paragraph 2 of this subsection does not apply to equipment for which the placement of a temperature measuring device is not a practical means for measuring the ambient air surrounding the food because of the design, type, and use of the equipment such as insulated food transport containers and salad bars. 4. Temperature measuring devices shall be designed to be easily readable. 5. Food temperature measuring devices and water temperature measuring devices on warewashing machines shall have a numerical scale, printed record, or digital readout in increments no greater than 1ºC or 2ºF in the intended range of use. Pf. Note: Manager placed a thermometer in the unit during the inspection.

Back to Food Inspections