Food Inspections

Dynamite Sushi Steak & Grill

Inpection Notes

4-2A - food stored covered 511-6-1.04(4)(c)1(iv) - packaged & unpackaged food, food stored covered(c) Points: 4 Corrected during inspection?: Yes Repeat: No Inspector Notes: Several food items were observed uncovered in front of the cook line station. Food items were also observed uncovered in the reach on refrigeration units. 511-6-1.04(4)(c)1(iv) - Packaged & Unpackaged Food, food stored covered(C) (iv) Except as specified under paragraph 2. of this subsection and when cooling as specified in DPH Rule 511-6-1-.04(6)(e)2.(ii), storing the food in packages, covered containers, or wrappings, except for loosely covered or uncovered containers in which food is being cooled if protected from overhead contamination; 4-2B - food-contact surfaces: cleaned & sanitized 511-6-1.05(6)(n) - manual and mechanical warewashing equipment, chemical sanitization-temperature, ph, concentration, hardness (p,pf) Points: 4 Corrected during inspection?: Yes Repeat: No Inspector Notes: The dish machine was observed with 0PPM of chlorine when tested with a chemical test kit. 511-6-1.05(6)(n) - Manual and Mechanical Warewashing Equipment, Chemical Sanitization-Temperature, pH, Concentration, Hardness (P,Pf) (n) Manual and Mechanical Warewashing Equipment, Chemical Sanitization - Temperature, pH, Concentration, and Hardness. A chemical sanitizer used in a sanitizing solution for a manual or mechanical operation at contact times specified under subsection (8)(b)3 of this Rule shall meet the requirements specified in DPH Rule 511-6-1-.07(6)(g), shall be used in accordance with the Environmental Protection Agency (EPA)-registered label use instructions P, and shall be used as follows: 1. A chlorine solution shall have a minimum temperature based on the concentration and pH of the solution as listed in the following chart; P Concentration Range Minimum Temperature MG/L PH 10 or less oF (oC) PH 8 or less oF (oC) 25-49 120 (49) 120 (49) 50-99 100 (38) 75 (24) 100 55 (13) 55 (13) Note: Facility immediately set up the (3) compartment sink and employees began to wash, rinse and sanitize all eqiuipment there. 11D - thermometers provided and accurate 511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c) Points: 3 Corrected during inspection?: No Repeat: No Inspector Notes: Several refrigeration units were observed with no thermometers in them. 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit. Correct the above violations compliance will be monitored in (10) days time.4/12/2025.

Back to Food Inspections