Food Inspections

Taqueria El Antojito

Inpection Notes

4-2A - food stored covered 511-6-1.04(4)(c)1(iv) - packaged & unpackaged food, food stored covered(c) Points: 4 Corrected during inspection?: Yes Repeat: No Inspector Notes: Several containers of food were observed uncovered at the front customer service area. 511-6-1.04(4)(c)1(iv) - Packaged & Unpackaged Food, food stored covered(C) (iv) Except as specified under paragraph 2. of this subsection and when cooling as specified in DPH Rule 511-6-1-.04(6)(e)2.(ii), storing the food in packages, covered containers, or wrappings, except for loosely covered or uncovered containers in which food is being cooled if protected from overhead contamination; Note: Foods were covered during the inspection. 4-2B - food-contact surfaces: cleaned & sanitized 511-6-1.05(7)(a)1 - equipment, food-contact surfaces,& utensils (pf) Points: 4 Corrected during inspection?: No Repeat: No Inspector Notes: Observed food slicer with accumulated food debris when disassembled. (b) Equipment Food-Contact Surfaces and Utensils. 1. Equipment food-contact surfaces and utensils shall be cleaned: (i) Before each use with a different type of raw animal food such as beef, fish, lamb, pork, or poultry. It does not apply if the food-contact surface or utensil is in contact with a succession of different types of raw meat and raw poultry each requiring a higher cooking temperature as specified under DPH Rule 511-6-1.04(5)(a) than the previous type such as preparing raw pork followed by cutting raw poultry on the same cutting board; P (ii) Each time there is a change from working with raw foods to working with ready-to-eat foods; P (iii) Between uses with raw fruits and vegetables and with Time/Temperature Control for safety food; P (iv) Before using or storing a food temperature measuring device; P and (v) At any time during the operation when contamination may have occurred. P 2. Except as specified in paragraph 3 of this subsection, if used with time/temperature control for safety food, equipment food-contact surfaces and utensils shall be cleaned at least every 4 hours throughout the day. P 11D - thermometers provided and accurate 511-6-1.05(2)(x) - tmd, located in refrigerators/ hot holding (pf, c) Points: 3 Corrected during inspection?: No Repeat: No Inspector Notes: The two walk in refrigeration units were observed with electronic Dataloggers which were connected to the owner's smart phone to monitor ambient temperatures of the units. The manager could not access the app on his phone and was not able to provide temperature readings for the (2) units. Manager was told to provide thermometers for the units. 511-6-1.05(2)(x) - TMD, Located in Refrigerators/ Hot Holding (Pf, C) (x) Temperature Measuring Devices. 1. In a mechanically refrigerated or hot food storage unit, the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit and in the coolest part of a hot food storage unit.

Back to Food Inspections